Publicité
5. Assembling display screen
A. Connect
the
signal
wire
from
display
screen
to
corresponding wire from controller. Crowding the extra wire
into controller.
B. Connect the display screen (7) to handlebar and controller
(6) using 4 sets of Half-round bolt M10X20(A8),Flat
washersφ10(C2).(Attention: To align screw hole)(See figure
5)
6. Assembling motor left & right cover
A.Tighten all the assembling bolt.
B.Install motor left cover (24) to left motor cover (23) of base
frame (1) using 1pcs Crosshead self-lock bolt ST4X30 (A9) in
front and 3pcs Crosshead self-lock bolt ST4X16 (A17) to
tighten.
C.Install motor right cover(25) to left motor cover(23) of base
frame (1) using 1pcs Crosshead self-lock bolt ST4X30 (A9) in
front and 3pcs Crosshead self-lock bolt ST4X16(A17) to
tighten.(See figure 6)
Treadmill adjustment
1.Before connect power, service or professional inspect if voltage is suitable, and if three-core plug grounded wire is
connected. Using hand to pull the belt, inspect if rotation is flexible and no noise.
2.Connect power, press Start key, treadmill will run slowly, inspect if belt and computer are normal.
3.Press incline +/- key, inspect treadmill rotation and display. If the belt is deviation, you must stop it to adjust belt
according daily maintenance.
4.Press the emergency button or remove the safety key to stop the treadmill immediately. After the safety key is
inserted again, the treadmill can be restarted only after the emergency button is reset.
5.Press Stop key, the treadmill stop to running, waiting incline back to zero class, turn off the power.
Treadmill can use after all the install adjustment is finished.
1.Two feet stand on two side of belt, put the other side clip from
safety key to clip to clothes. (see figure)
2.Press Start key, the treadmill will run slowly. You can step on
belt slowly.
3.Press speed+ key, the belt speed will gradually increase, you
can see the speed data from computer, after run is suitable, you
can let go handrail to run.
4.When stop running, should gradually slow, and run 2-3
minutes in slow speed, put the heart and breathe back to
normal.
5.At the end of run, you can reduce belt speed to the lowest, and
the treadmill will stop when pressing stop key.
6.If it is too late to reduce speed and lose balance when high
speed running, you can press or pat the emergency button,
treadmill will stop to run immediately. Its stopped distance
according to inertia and weight.
7.Please fully master emergency button and safety key usage.
Publicité
