Publicité
4.2 Introduction to the panel
1
2
7
8
9
NUM.
Name
1
Input voltage
2
Temperature display
3
Adjustment wheel
4
Welding mode selection
5
PULSE / SPOT selection
6
2T/4T selection
7
Pre-gas (s)
8
I
(A)
S
9
T
(s)
UP
10
I1 (A)
11
PULSE FREQUENCY (H
12
I2
13
PULSE RATIO (%)
14
TDOWN (s)
15
IE (A)
16
Post-gas (s)
Notices_multilangues_220DC.indd 23
Notices_multilangues_220DC.indd 23
3
10
11
12
Effect
Indicates that the device is connected to a power source.
Indicates that the machine is protected against overheating.
Press to confirm and select another setting. Turn to adjust value
LIFT TIG: TIG mode - arc start by touch
TIG: TIG mode - high-frequency starting arc
MMA: coated electrode welding mode
PULSE: pulsed TIG welding
SPOT: TIG welding for tacking
2T - 2-stroke mode
4T - 4-stroke mode
Gas diffusion time before arc ignition
Starting arc current
If SPOT active: S
welding arc current
POT
Time needed to go from I
to I1
S
Welding current
If PULSE active: Pulsed high peak current
If SPOT active: TIG time per point (in ms)
)
Pulse frequency. Number of cycles per second
Z
If PULSE active: Low pulse current (as % of I1)
If SPOT active: TIG interval time between each point (in s)
Ratio of peak current to base current
Fading: time taken to go from I1 to IE
End of arc current
Gas flow time after arc fade
13
14
15
16
4
5
6
23
18/03/2024 13:27:00
18/03/2024 13:27:00
Publicité
