Cembre B1350-UC Notice D'utilisation Et Entretien page 13

5. CRIMPING OF CONNECTORS USING THE CIRCULAR OR HEXAGONAL COMPRESSION
SYSTEM (
Ref. to Figs. 4, 5)
5.1) Connector crimping
Fit upper adaptor AU130-C into the head (see § 6.1).
Select the appropriate die set for the connector to be
crimped.
Insert die set into the head (see § 6.3).
Insert the conductor into the connector.
Position the connector between the dies and ensure the
correct location of the crimp.
To crimp connector continue as § 2.2.
NOTE: when more compression is
required, proceed according to the
sequence and direction indicated
in the figure, uniformly spacing the
compressions.
6. ACCESSORIES ASSEMBLY/REMOVING
6.1) Upper adaptors
Insert the adaptor in the guides on the U-fork (33) until securely located, with the grooves on the
adaptor corresponding to the locators (06) on the U-fork head (10).
Remove the adaptor by pushing it off the locators and sliding from the head.
6.2) Lower adaptor and Indentors
To insert AC130-P lower adaptor or indentor PS.../E press release botton (04) and insert them
into the seat on the ram (14) until secured by the die retaining pin (02).
To ease this operation, operate the tool to advance the ram (14) 15-20 mm (0.6 - 0.8 in.).
To remove, press the release button (04).
6.3) Semicircular slotted dies
Press release botton (08) and insert the upper die (88) into the AU130-C adaptor (09) until secured
by the die retaining pin (07).
To remove the upper die, press the release button (08).
Press release botton (04) and insert the lower die (89) into the seat on the ram (14) until secured
by the die retaining pin (02).
To ease this operation,.operate the tool to advance the ram (14) 15-20 mm (0.6 - 0.8 in.).
To remove the lower die, press the release button (04).
13
terminal
(Ref. to Figs. 3, 5)
(Ref. to Fig. 3)
(Ref. to Fig. 5)
2
1
2
Connector
2
connector
1
1