Publicité
Controls
Temperature Control
the room at the same level of comfort.
NOTE:
room temperature.
Fan, Mode and Operation Control
FAN – Sets the fan operation for HIGH or LOW.
MODE – COOL – For cooling
FAN – For fan-only operation
HEAT – For heating
POWER –
constant fan, humidity sentinel, makeup air, and defrost
features still function if active. See Freeze/Heat Sentinel
section on page 9.
USE WALL THERMOSTAT—
when the unit is controlled by a wall thermostat. See
About Your Heat Pump
Heat pumps can save money by capturing heat from the
outside air—even when the outside temperature is below
freezing—and releasing that heat indoors.
pump, don't change the room thermostat by more
than one degree at one time. Raising the heat setting
heating elements in order to reach the new temperature
setting quickly.
heat pumps and cost more to operate.
any setting to prevent short cycling.
compressor cycles off.
6
(AZH and AZV only)
Control Lock Out
from changing operation mode of the unit. While the unit
is in the desired operating mode, press and hold MODE
lock the control and desired setting.
NOTE: When switching between modes, it may take
several minutes to completely change operation.
For all AZH models and those AZV models equipped
with Internal Condensate Removal, When the outdoor
the electric heater instead of by the heat pump. When
operation is locked out. Cooling operation will resume
For AZV models not equipped with Internal
Condensate Removal, When the outdoor temperature
heater instead of by the heat pump. When the outdoor
49-5001038 Rev. 1
Publicité
