Publicité
ENGLISH
(Original instructions)
1
Hook
2
Bolt
3
Lock-off button
4
Lever
5
Switch trigger
6
Graduation
7
Indicator
8
Vise stop
9
Dust box
SPECIFICATIONS
Model
Blade diameter ................................................................................................................................................... 305 mm
Hole (arbor) diameter ........................................................................................................................................ 25.4 mm
Max. kerf thickness of the saw blade.................................................................................................................... 2.5 mm
No load speed ............................................................................................................................................... 1,700 min
Dimensions (L x W x H) ......................................................................................................516 mm x 306 mm x 603 mm
Net weight ............................................................................................................................................................ 19.2 kg
Safety class ..............................................................................................................................................................
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014
Cutting capacity
Workpiece shape
Cutting angle
90°
45°
Intended use
The tool is intended for cutting in mild steel and stainless
steel with appropriate saw blades.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under unfavor-
able mains conditions can have adverse effects to the
operation of other equipment. With a mains impedance
equal or less than 0.25 Ohms it can be presumed that
there will be no negative effects. The mains socket used
for this device must be protected with a fuse or protective
circuit breaker having slow tripping characteristics.
Explanation of general view
10 Wrench holder
11 Base
12 Center cover
13 Hex bolt
14 Socket wrench
15 Blade guard
16 Shaft lock
17 Carbide-tipped saw blade
18 Spindle
115 mm
90 mm
ENE008-1
SAFETY WARNINGS
General power tool safety warnings
ENF002-2
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
ENF100-1
(cordless) power tool.
19 Inner flange
20 Outer flange
21 Vise plate
22 Vise nut
23 Vise handle
24 Limit mark
25 Screwdriver
26 Brush holder cap
A
WARNING Read all safety warnings, instructions,
LC1230
75 mm x 150 mm
100 mm x 100 mm
85 mm x 85 mm
GEA010-2
–1
/II
9
Publicité
