Publicité
LED (2) will turn green once the battery is fully charged.
NOTE: Before the first use or after a long product storage, it is recommended to fully charge the Parent Unit prior to operating the monitor. It
takes approximately 8 hours to fully charge the battery.
NOTE: The monitor can be operated normally during the charging process.
NOTE: Low Battery Warning - The battery icon turns red on the LCD screen to indicate that the battery is low. The warning is accompanied
with an acoustic beep sound, indicating that the battery needs to be recharged. *
* Alert Volume can be adjusted in the Parent Unit menu, see details in Section Warning Alert" Volume Setting".
3.4 Set Up
•
Once both the Baby and Parent Units are switched on, the display on the Parent Unit will show the video captured by the Baby Unit(s).
•
Baby Unit(s) are paired to the Parent Unit when supplied. There is no need to pair the units again unless the Baby Unit loses its link with the
Parent Unit. To renew the pairing of your units or pair a new/additional Baby Unit, follow the procedure described in "Section 4.4 Pairing the
Baby Unit (Camera) with the Parent Unit".
•
The Baby Unit should be placed at least 6 feet away from the baby's crib on a flat surface. Alternatively, it can be wall mounted.
•
Never place the Baby Unit inside the crib, bed or playpen.
• Make sure the unit and cords are out of reach of the baby and other young children.
• To avoid a strangulation hazard, the power cords should be secured and never hung on the crib or near the baby.
•
Place the baby monitor in a place where the air can circulate freely and avoid blocking the ventilation and speaker openings.
•
Aim the camera (s) to best optimize the viewing area: Select a location for the camera that provides a clear view of the area you want
to monitor, which is free from dust, and is not in line-of-sight to a strong light source or direct sunlight. Avoid installing the camera where
there are thick walls or obstructions between the camera and the monitor.
•
To use your Parent Unit and Baby Unit together, you must be able to establish a radio link between them; the range may be affected by
environmental conditions/obstacles (See more details in Troubleshooting Section 6 - "Interference or poor reception")
4. Operating the Monitor
4.1 Lullaby & White Noise Setting
You can soothe your baby to sleep by playing 5 pre-programmed lullabies from the Baby Unit.
The monitor also features White Noise, which is an effective way to soothe a crying infant and lull your newborn to sleep. The Lullaby and White
Noise features are is controlled remotely from the Parent Unit.
EN
9
Publicité
