Publicité
EN
4.17 SCAN Mode - Automatic switching between the paired Baby Units (Cameras)
You can set the SCAN (loop) mode and each paired Baby Unit will be displayed on the screen for 15 seconds and then the screen will
automatically change to the next paired Baby Unit.
Press and hold the CAMERA SWITCH button (11) to activate the automatic SCAN mode. A SCAN MODE ON message will appear on the screen
•
and a loop sign will appear next to the camera number on the top of LCD screen.
Press the CAMERA SWITCH button (11) to deactivate the Scan mode
•
4.18 Talk to Baby
•
Press and hold the
on your Parent Unit to talk to your baby or partner in the baby's room via Baby Unit.
•
Release the button when you are finished talking.
NOTE: While the "Talk to Baby" function is in use, there is no possibility to hear the sounds from the Baby Unit. Releasing the talk button allows
one to hear the sounds from the baby's room again.
4.19 Parent Unit Screen ON/OFF (Audio only mode)
•
Press the POWER button (1) to turn the LCD screen ON/OFF
5. Maintenance
All of the following maintenance procedures should only be performed when Baby and Parent Units are unplugged and off.
•
Clean the surfaces of the Baby and Parent Units with a soft, fluff-free cloth.
•
Never use cleaning agents or solvents.
•
If the units become dirty, use a lightly damp cloth to wipe surfaces, taking care not to allow water into any openings.
18
Publicité
