Publicité
Bridge function
The hob allows you to associate two cooking zones where you can use
large/long pans or cook several dishes at the same time, with maximum
flexibility in the positioning of pans.
To enable or disable the bridging function, the user must press both selection
keys
will illuminate indicating that the bridge has been established.
In some cases, the user will not be able to activate the "bridge key combination",
so three short beeps are heard. These cases are as follows:
- If the power level of the cooking zones is higher than "0".
- If the keys lock is activated.
To set the power level of the bridge cooking zone press the "slider" control
The power level of the bridged cooking zone is shown in the cooking zone displays.
When the cooking zones operate as a bridge cooking zone, the selectable power levels are 1 to
9, Power Boost cannot be selected. (When the cooking zones are operated individually, the
power levels are 1 to "P".
When the cooking zones operate as a bridged cooking zone and you wish to switch them off at
power level "0", press the two cooking zone selection keys and the bridged cooking zone
switches to power level "0" and the bridging function is deactivated.
When the cooking zones are operating in bridge mode, and one of the cooking zones does not
have a suitable utensil or no utensil, the zone with utensil will display the power level and the
zone without utensil will display that it does not detect the utensil . After 1 minute, the
cooking zone without a suitable container or without a container is switched off and the
bridging function is deactivated.
Heat retention
This function allows you to maintain the temperature (70ºC) of the food in a delicate way,
without reaching boiling temperatures or burning the bottom of the utensils.
The heat retention function is activated by pressing the
zone has been selected and the symbol
The heat retention function can be activated on all cooking zones independently of each other.
Once the cooking zone has been selected, the heat retention function will end if:
-
Another function/power level is selected.
-
The heat retention function is pressed again, the heat is turned off.
-
If 2 hours elapse from the defined start to retain the heat.
When heat retention function is deactivated, the cooktop will operate at power level "1". Quick
of the zones to be bridged. A beep and an LED dot in each of the zones
is shown in the cooking zone display.
key only when the desired cooking
14
.
Publicité
