Publicité
Installing the induction hob
When installing the induction hob, please observe the following instructions:
-
Double check the worktop cut-out measurements.
-
Keep the edges of the cut-out clean and free of grease.
-
Glue the sealing gasket around the perimeter of the glass.
The edge of the induction hob must be parallel to the front edge of the worktop.
-
Slowly lower the induction hob into the cut-out until it rests on it.
-
Press the edge of the induction hob all the way around.
-
Note the position of the mounting clamp depending on the worktop thickness.
-
Fasten the hob onto the worktop from below with:
o 4 fastening clamps.
o 4 screws.
Attach the fastening clamps
Back of induction hob
1
Worktop
2
Screws 3.5x9.0
3
Fastening clamp
4
Hob
5
Sealing gasket
9
Publicité
