Publicité
Store after Cleaning
Steps
1. Store WINBOT
Place WINBOT with its front facing outward and the Compound Cable exit end facing
upward. Then, insert WINBOT from top to bottom into the Station's storage compartment,
ensuring that WINBOT hangs on the hooks in the storage compartment.
* When storing WINBOT, remove the wet mopping pad. Store the mopping pad after it is
dried to avoid any unpleasant odors.
18
EN
JA
2. Reel in the Compound Cable
After placing WINBOT into the storage compartment, press the Reeling In Button, and the
Station will immediately start reeling in the Compound Cable .
* As the reeling-in process nears completion, the reeling-in speed slows until the cable is
fully reeled in. This is a normal occurrence; do not worry.
* During the reeling-in process, the Compound Cable may become twisted. Do not worry
and help straighten it. Then press the Reeling In Button again to complete the reeling-in
process.
3. Power Off
Press and hold the Power Button on the Station for 2 seconds and more to power off
WINBOT.
* If WINBOT is powered on but the fan is not working, and you do not operate any
buttons on the Station or WINBOT for an extended period ( ≥ 10 minutes), WINBOT will
automatically power off. To use WINBOT again, long press and hold the Power Button on
the Station to turn on WINBOT.
Unfasten Safety Tether
Publicité
