Publicité
I Installed System Setting
After the completion of installation work, system setup shall be made according to the equipment to be connected and the oper-
ation mode.
Setup operation for the installed system shall be carried out by the use of the PREV/NEXT button and the SEL button.
Indicator of the selected setup item blinks.
ECHO CANCELLER
AUX IN
TALK
AUX
SP
PAGE
BEEP
INSTALL SYSTEM SETTING
PREV
PREV button
1. Turn on the power supply of the center module.
2. Press the [NEXT] button or the [PREV] button.
Indicator of the selected setup item blinks. Each time the
[SEL]
button
is
changeover between ON Select and OFF Select status.
The ON/OFF status can be defined by the style of indi-
cator blinking.
G Setup operation for AUX SP (Auxiliary Speaker)
The sound output is set up for the AUX SP.
Setup item
AUX SP
26
DUAL LANE
DNR LEVEL
LANE SELECT
POS REMOTE
RED
MAX
YELLOW MD
TX POWER
GREEN LOW
OFF
OFF
SEL
NEXT
NEXT button
SEL button
pressed,
there
is
a
AUX IN
AUX IN audio is output to the auxiliary speakers.
TALK
TALK audio is output to the auxiliary speakers.
* The sound of Outside Mic is also output to AUX SP.
PAGE
PAGE audio is output to the auxiliary speakers.
BEEP
BEEP audio is output to the auxiliary speakers.
OFF: Lighting time is short and unlighting time is long.
ON: Lighting time is long and unlighting time is short.
OFF:
ON:
3. When the ON/OFF is changed over, the selected status
is reflected on the system in real-time.
4. When the [NEXT] button is pressed, the next setup item
is selected. (The setup item being selected is moved by
one to the lower position or to the top right.)
When the [PREV] button is pressed, the previous setup
item is selected. (The setup item being selected is
reciprocal
moved by one to the upper position or to the bottom
left.)
5. If any [NEXT], [SEL], or [PREV] button is not pressed for
10 seconds, blinking of the indicator is finished.
ON (Green)
Lit
Unlit
Lit
Unlit
No output
No output
No output
No output
OFF
Publicité
