Publicité
CAUTION
IF THE BRUSH SAW BLADE BECOMES
BLOCKED, DO NOT PULL THE PRODUCT WITH
A SUDDEN MOVEMENT. THAT CAN CAUSE
DAMAGE TO THE BLADE, GEAR, SHAFT OR
HANDLE. RELEASE THE HANDLES, HOLD THE
SHAFT WITH BOTH HANDS AND CAREFULLY
PULL THE PRODUCT.
Note: For optimal results, apply increased cutting
pressure to fell small trees. Use less cutting pressure
for felling large trees.
5.4
STOP THE PRODUCT
1.
Release the trigger.
2.
Push the power button for 2 seconds to turn the
product off.
3.
Push the battery release button (1) and pull out
the battery to fully stop its operation.
1
WARNING
WAIT UNTIL THE MOTOR STOPS BEFORE YOU
REMOVE THE BATTERY.
6
MAINTENANCE
This section describes how to maintain the battery,
battery charger, and product.
English
CAREFULLY READ AND UNDERSTAND
THE SAFETY CHAPTER AND OPERATION
INSTRUCTIONS BEFORE YOU DO ANY
MAINTENANCE WORK.
Before you do maintenance:
• Stop the product.
• Remove the battery.
• Allow the motor to cool.
• Use correct clothing, protective gloves, and safety
glasses.
6.1
EXAMINE THE BATTERY AND THE
BATTERY CHARGER
Carefully inspect the battery, battery charger, and
connection cord of the battery charger for any signs
of damage, such as cracks or broken parts. Replace if
necessary.
6.2
CLEAN THE PRODUCT, THE BATTERY,
AND THE BATTERY CHARGER
• Clean the product after each use with a moist cloth
and neutral detergent.
• Do not use strong detergents or solvents like "glass
cleaner" to clean the plastic parts or handles.
• Keep the trimmer head free from grass, leaves, or
excessive grease.
• Keep the air vents clean and free of debris to avoid
overheating and damage to the motor.
• Do not spray water on the motor and electrical
components.
• Clean the battery and battery charger with a dry
cloth. Keep the battery guide tracks clean.
• Prior to inserting the battery into the battery charger,
ensure that the terminals on both the battery and the
battery charger are clean.
6.3
CLEAN THE AIR INLET GUARD
Note: To ensure product efficiency and prolong its
lifespan, it is recommended to clean the air inlet guard
at 50-hour intervals.
1.
Loosen the screw on the air inlet guard.
2.
Slide downward to remove the air inlet guard.
19
WARNING
EN
Publicité
