Publicité
3.
Tighten the locknut counterclockwise with the
socket wrench, while firmly holding the metal rod
in place.
4.
Remove the metal rod.
4.2.2.4 REMOVE THE BRUSH CUTTER BLADE
1.
Insert the metal rod into the specified angle
transmission hole, and hold in place. Turn the
blade until the metal rod blocks rotation of the
blade.
2.
Loosen the locknut clockwise and remove the
outer cap.
English
3.
Remove the support flange and brush cutter
blade.
4.2.3
INSTALL THE BRUSH SAW GUARD AND
THE BRUSH SAW BLADE
4.2.3.1 INSTALL THE BRUSH SAW GUARD
1.
Place the brush saw guard onto the mounting
posts.
2.
Securely tighten the screws with the torx wrench.
4.2.3.2 REMOVE THE BRUSH SAW GUARD
1.
Remove the screws from the brush saw guard
with the torx wrench.
2.
Remove the brush saw guard.
11
EN
Publicité
