Publicité
2.
Attach the shoulder straps to the D-rings at the
back of the hip-belt.
Note: The back padding must fit firmly and securely on
your back.
3.
Adjust and fasten the hip-belt to suitable position
on your hips.
4.
Lock the quick-release clasp buckles together.
5.
Pull the ends of the straps down to tighten the
harness.
6.
Attach the harness to the strap bracket. Adjust
the harness until the cutting attachment is parallel
to the ground.
English
7.
Adjust the side straps until the weight is equally
distributed across your shoulders.
5
OPERATION
This section describes how to operate the product.
CAREFULLY READ AND UNDERSTAND
THE SAFETY CHAPTER AND OPERATION
INSTRUCTIONS BEFORE YOU OPERATE THE
PRODUCT.
5.1
BEFORE YOU USE THE PRODUCT
5.1.1
INSPECT SAFETY FEATURES
ALWAYS REFER TO THIS SAFETY INSPECTION
LIST BEFORE AND AFTER OPERATING THE
PRODUCT.
• Examine the work area to identify any potential
hazards, such as uneven terrain, slopes, rocks,
branches, or ditches.
• Perform all required safety inspections,
maintenance, and servicing as specified in this
manual.
• Check that all covers, guards, handles, and cutting
equipment is properly attached and undamaged.
• Inspect the brush cutter blade and brush saw blade
for cracks, especially around the bottom teeth and
the center hole. Replace the blade if it is damaged.
• Examine the support flange for cracks, damage, and
replace if necessary.
13
WARNING
WARNING
EN
Publicité
