Publicité
Option 3 – (Garbage Disposal - No Air Gap):
Remove the knockout drain plug from the disposal inlet. Using a
1.
screwdriver and hammer, firmly tap the plug. The plug will separate
and fall into the disposal.
Remove the drain plug from the disposal.
2.
IMPORTANT: If you need to cut the drain hose to fit the diameter of the
connection, cut only the rubber end of the hose, as shown earlier in this
section (do not cut into the ridged section).
Using a screw-type clamp*, attach the drain hose to the garbage
3.
disposal inlet.
NOTES:
This connection must be located before the drain trap and at least 20"
•
(50.8 cm) above the floor where dishwasher will be installed.
It is recommended that the drain hose be looped up and securely
•
fastened to the underside of the counter at a minimum height of 32"
(81.3 cm).
30
d
* Parts available from local plumbing supply store.
a
a
b a
a
b
c
c
d
a
Disposal Inlet
a
Disposal Drain Plug
Drain Hose
Screw-Type Clamp
Garbage Disposal
Inlet
Drain Trap
32"
Min.
18"
Min.
Publicité
