Publicité
Position the end of the elbow so that it faces the bottom left of the
2.
dishwasher.
PREPARE INSTALLATION OPENING
The wiring and plumbing may enter the opening from either the right-
•
hand or left-hand side of the rear wall, the side cabinets, or the floor
within the shaded area. See "Location Requirements" for dimensions.
NOTE: Connecting the dishwasher to utilities will be easier if you route
the wiring into the installation opening from the right-hand side and
the plumbing from the left-hand side.
IMPORTANT: Any plumbing or electrical line run outside of the shaded
area can become pinched.
The direct wire cable may enter the opening through either the
•
same hole used for the drain hose and hot water line or through an
1/2
additional 1
" (3.8 cm) diameter hole.
NOTE: The hole must be free of sharp edges. If the cabinet wall is
metal, the edge of the hole must be covered with a bushing/grommet.
Power cords with a plug MUST pass through a separate hole.
•
b
NOTE: After installation, the elbow
face the dishwasher card slot at the right
on the bottom.
a
a
a
a
Possible Utility
Hole Locations
a
Preferred Electrical
Locations
b
Preferred Plumbing
Locations
should
15
Publicité
