Publicité
CONNECT DRAIN HOSE TO DISHWASHER
Grasp the sides of the dishwasher at the edges of the door panel, and
1.
place the dishwasher in front of the opening.
Insert the drain hose into the hole in the cabinet wall.
2.
Attach drain hose to the back of the dishwasher and secure with a
3.
hose clamp.
a
SLIDE DISHWASHER PARTIALLY INTO OPENING
WARNING
Position power supply.
1.
If dishwasher has a power supply cord, insert power supply cord
•
into the hole cut into the cabinet.
If using a direct-wire connection, check that the wiring is on the
•
right front side of opening.
Make sure the drain hose is not kinked under the dishwasher and
2.
there is no interference with the water line and wiring or any other
component.
Slowly move the dishwasher into the opening a few inches at a time.
3.
As you proceed, pull the drain hose, water supply hose and cord
through the opening under the sink or cabinet. Stop pushing when the
dishwasher is a few inches in front of the adjacent cabinetry.
b
c
d
e
Tip Over Hazard
Do not use dishwasher until completely installed.
•
Do not push down on open door.
•
Doing so can result in serious injury or cuts.
•
a
Insulation Blanket
b
Water Line
c
Drain Hose
(Maximum Length
10 ft [3.0 m])
d
House Wiring
e
Power Cord (If
Used)
21
Publicité
