Publicité
Attach copper tubing to the manual shutoff valve.
3.
a
Slowly feed the copper tubing through the hole into the opening.
4.
Continue feeding the tubing, until there is enough length to connect to
the inlet (front, left-hand side of the dishwasher) yet remain within the
required boundary.
¾
3" to 4
(7.6 cm to 12.1 cm)
Slowly turn water shutoff valve to "ON" position. Flush water into a
5.
shallow pan to get rid of particles that may clog the inlet valve.
Turn shutoff valve to "OFF" position.
6.
PREPARE TO CONNECT DRAIN HOSE
The drain hose will be connected to the house drain system after the
dishwasher is installed in the opening.
1/2
Drill a 1
" (3.8 cm) hole in cabinet wall or floor on the side of the
1.
opening closest to the sink.
INSTALL MOUNTING BRACKETS
IMPORTANT: The dishwasher must be secured with mounting brackets to
the countertop or adjacent cabinets to keep it from tipping when the door
is opened.
Some countertop materials, such as granite, do not accept screws; and
therefore, do not lend themselves to a countertop installation.
b
a
"
a
Preferred Locations
b
Optional Locations
a
Copper Tubing
19
Publicité
