Publicité
TIRE CHANGER WITH LEVERLESS 13-28"
DM 1900
2 SPEED SYSTEM 400V
• After the demounting head into the tire lip, pull upward the control valve to lift the tire lip onto
the circular convex part of demounting head like FIG30. At this time, step the rotation pedal to
observe the tire lip and demounting hook, if there's no abnormality, step down the rotation pedal
to rotate the turntable clockwise to take out the upper side of tire lip.
• If the demounting hook cannot lift the tire lip because of the harder RSC tire during lifting the tire
lip, can press the tire using assist arm. The pressing block can press down 4-8cm on the opposite
side of the demounting head, which helps the demounting hook to lift the tire lip smoothly like
FIG31.
Mount tire
Before mount the tire, check that the tire and rim size are the same!
• Clean up the oil and rust on the rim and lock the rim on the turntable. Note: the demount groove
must be at upper side to mount. Spread the lubrication liquid or soap liquid around the lip. Tilt the
tire against the rim and keep the front end upwards. Press down the column tilt pedal to make the
column return to the original position. Move the demount head to firmly contacted rim. Position
the left of the lip above the tail of the demount tool and the right under the hump of the demount
tool (FIG34). Press down the right side of the tire as hard as you can and step turntable pedal to
rotate the turntable clockwise to guide the lip into the tire detach slot completely.
If the demount of the tire is jammed, please stop the
machine immediately and then lift up the
pedal to let the turntable rotate counterclockwise to
remove the resistance!
• After separate the upper tire lip, take out the inner tube
if has. Lift the lower tire lip to rim edge. Lower the hook
and take the lower tire lip like FIG32 then step the
rotation pedal to separate the lower side.
• Then step the tilt pedal (FIG3-10) to tilt the column back
and take out the tire like FIG33. Finish the demounting tire
operation.
FIG 31
FIG 34
FIG 33
FIG 35
Publicité
