Publicité
TIRE CHANGER WITH LEVERLESS 13-28"
DM 1900
2 SPEED SYSTEM 400V
1 Hexangular shaft
2 Knob
3 lifting cylinder of demounting hook
4 lifting cylinder of hex shaft
5 Handle valve
6 Demounting head
7 Turntable
8 Clamping cylinder
9 Clamping jaw
10 Column tilt pedal
11 Clamp pedal
12 Bead breaker pedal
13 Turntable turning pedal
14 crowbar
SETUP
Carefully read the manual before installation and the change on the parts of the machine without
the permission of the manufacturer;
• Installation person must have some knowledge relating to electrical;
• You must carefully check the equipment list and contact the dealers or our company if you are
in doubt;
Open the box
In accordance with the instruction on the package box, open the package box and remove the
package material and check if the machine is sounded and the accessories if completed.
Keep the package material far away from the working site and treat it well.
Air test
• Column tilt back : Connect the air and press down the lock valve button (FIG3 3) to lock the
horizontal arm. Step down column tilt pedal (FIG3 10) and the column tilt back by 25º. The tilt
speed has been setup before ex work at about 2 seconds. After longtime of use, the speed will
be fast or slow and on this condition, you can use the speed valve at the heads of the push out
cylinder to adjust. Loose the nut and turn adjust screw clockwise, the speed will be slow and it will
be slow if counterclockwi se, tight the nut after adjust. When the machine out of the factory, the
air source fitting has been adjusted well and if you need to change, you can readjust.
• Before the machine out of the factory, the air regulator has been adjusted well and can be re
adjust if need.
Adjust the pressure: lift
up the adjusting knob (FIG21 B) and rotate it clockwise, the pressure will raise. Otherwise, decline.
Press down the adjusting knob after adjusting.
Adjust the oil feed: twist the adjusting screw (FIG21 A) clockwise using the screw driver to slow
the dripping speed and otherwise, quicken it.
15 Breaker blade
16 Pin
17 Bead breaker cylinder
18 adjusting bushing
19 Breaker blade handle
20 Bead breaker arm
21 Air tank
22 control valve of demounting hook
23 vertical column
24 Inflation g auge
25 Exhaust valve
26 Air regulator
27 Quick inflation pedal
FIG 21
Publicité
