Publicité
TIRE CHANGER WITH LEVERLESS 13-28"
DM 1900
2 SPEED SYSTEM 400V
After bead breaking, step the clamp pedal (FIG3 11) to open the clamps till 3cm 5cm bigger than
rim diameter. Put the whee l onto the turntable and press down the wheel center. Step the clamp
pedal to fix the wheel firmly. If the tire wall is hard and the clamps cannot enter the joint of the rim
and tire. The assist arm can be used for the assistant operation. Align the press plate to the rim
center then press down 2cm 3cm so that the rim can be smoothly clamped.
•Press the control valve (FIG3 5) to the middle position, the demounting head should fall down to
the working position. Make the demount tool close to the rim of the wheel. The protection cover
and plastic tail cover in the demount head will contact with the rim edge. If the tire wall is hard, use
the press plate of assist arm to press the tire lop down like FIG26. Then press the control
valve button to lock the horiz ontal arm . At this time the demounting head will move slightly away
the rim automatically to separate the demounting head and rim to avoid scratching the rim like
FIG27.
• If there has inner tube in tire, in order to avoid damage the inner tube, the demounting hook
should be operated about 10cm away from the left side of the valve as shown in FIG28.
FIG 25
FIG 28
FIG 29
FIG 26
•Pull down the control valve (FIG3-22) of demounting hook to make the
demounting hook enter the inner side of tire lip. If the demounting hook
does not insert into the inside of tire lip when down to the bottom, step
the rotation pedal to rotate the turntable a little to make the hook insert
into the inside of tire lip like the FIG29. If the tire lip is harder, use the
press plate of assist arm to press down the tire lip so that the hook can
insert into the inside of tire lip smoothly.
FIG 27
FIG 30
Publicité
