Publicité
Q: There is no power in the MDCI Lite dongle after connecting to the vehicle's DLC port.
A:
Possible Cause
Poor contact of the MDCI Lite dongle.
Poor contact of vehicle's DLC port.
Too low voltage of the vehicle battery.
Fuse blown.
Q: The tablet cannot establish a connection with the MDCI Lite dongle.
A:
Possible Cause
Poor contact of the MDCI Lite dongle.
The firmware is damaged.
Q: Can I use other chargers to charge the tablet?
A: No, please use the original charger provided by TOPDON.
Any damage and economic loss caused by using the improper battery charger will not be our
responsibility.
Q: How to save the battery power?
A: Please switch off the screen while the tablet is idle, or set a short standby time, or reduce the
brightness of the screen.
Q: Are there non-standard OBDII adapters in the box?
A: Yes.
40
Solution
Plug out the MDCI Lite dongle, and then
plug it in again.
Plug out the MDCI Lite dongle, and then
plug it in again.
•
Recharge the vehicle battery.
Replace the vehicle battery if it
•
is damaged.
Check the fuse of the OBD module.
Solution
•
Plug out the MDCI Lite dongle, and
then plug it in again.
Perform the MDCI Lite Bluetooth
•
pairing again.
Enter the settings and tap "Fix MDCI
Firmware/System" to fix the firmware.
Publicité
