Publicité
If any of the following marks is displayed, take the specifi ed action, then
repeat the operation.
00̲CH452̲ACN̲all.indb Eng-20
00̲CH452̲ACN̲all.indb Eng-20
KEY TO DISPLAY ICONS
Icon displayed
Displayed during
measurement.
Displayed during
measurement.
Icon displayed
Lit
Blinking
"PUL Err" is displayed when the pulse
value is below 40 or above 181.
Condition/Cause
• Appears when the
blood-pressure could
not be measured
accurately.
The pressure is
281 mmHg or higher.
Appears when the
batteries are running low.
Detected problem in the
device.
-
-
Eng 20
Condition/Cause
Measurement is under way.
Pulse detected.
Corrective action
Apply cuff properly and
measure again.
If the pressure does not
automatically decline
during measurement,
immediately press the
"START/STOP" switch
and turn the unit off. Take
the measurement again.
Replace the batteries.
Contact the vendor.
2012/09/18 18:49:49
2012/09/18 18:49:49
Publicité
