Safety Instructions - Zanussi ZFX31400WA Manuel D'utilisation

defrosting process, other than those recommended by the manufac-
turer.
• Do not damage the refrigerant circuit.
• Do not use electrical appliances inside the food storage compart-
ments of the appliance, unless they are of the type recommended by
the manufacturer.
• Do not use water spray and steam to clean the appliance.
• Clean the appliance with a moist soft cloth. Only use neutral deter-
gents. Do not use abrasive products, abrasive cleaning pads, sol-
vents or metal objects.
• Do not store explosive substances such as aerosol cans with a
flammable propellant in this appliance.
• If the supply cord is damaged, it must be replaced by the manufac-
turer, its service agent or similarlyqualified persons in order to avoid
a hazard.

Safety Instructions

Installation
WARNING! Only a qualified person
must install this appliance.
• Remove all the packaging.
• Do not install or use a damaged appliance.
• Obey the installation instruction supplied
with the appliance.
• Always be careful when you move the ap-
pliance because it is heavy. Always wear
safety gloves.
• Make sure the air can circulate around the
appliance.
• Wait at least 4 hours before connecting the
appliance to the power supply. This is to
allow the oil to flow back in the compressor.
• Do not install the appliance close to
radiators or cookers, oven or hobs.
• The rear of the appliance must stand
against the wall.
www.zanussi.com
• Do not install the appliance where there is
direct sunlight.
• Do not install this appliance in areas that
are too humid or too cold, such as the
construction appendices, garages or wine
cellars.
• When you move the appliance, lift it by the
front edge to avoid scratching the floor.
Electrical connection
WARNING! Risk of fire and electrical
shock.
• The appliance must be earthed.
• All electrical connections should be made
by a qualified electrician.
• Make sure that the electrical information on
the rating plate agrees with the power sup-
ply. If not, contact an electrician.
• Always use a correctly installed shockproof
socket.
• Do not use multi-plug adapters and exten-
sion cables.
15