Publicité
ATTENTION! Hot surface .
There is a risk of burns .
Before use
Charging the battery pack (see fig . A)
CAUTION!
►
Always pull out the power plug before you
remove the battery pack from or connect the
battery pack to the charger .
NOTE
►
Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C .
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly . The optimum charge level
is between 50% and 80% . The storage cli-
mate should be cool and dry and the ambi-
ent temperature should be between 0°C and
50°C .
♦
Connect the battery pack
battery charger
♦
Insert the power plug into the socket . The control
LED
lights up red .
♦
The green LED
indicates that the charging
process is complete and the battery pack
is ready for use .
CAUTION!
♦
If the red control LED
that the battery pack
cannot be charged .
♦
If the red and green control LEDs
flash, this means that the battery pack
defective .
♦
Push the battery pack
♦
Switch off the charger for at least 15 minutes
between successive charging sessions . Also dis-
connect the power plug from the mains power
socket .
PASSK 20-Li A1
All manuals and user guides at all-guides.com
to the high-speed
(see Fig . A) .
flashes, this means
has overheated and
both
back into the appliance .
Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack
♦
Push the rotation direction switch
middle position (lock) . Push the battery pack
into the handle until it clicks into place .
Removing the battery pack
♦
Press the release button
battery pack
Checking the battery charge level
♦
Press the battery charge level button
check the status of the battery (see also main
diagram) .
The status/remaining charge will be shown on
the battery display LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Use
Switching on and off
Switching on
♦
To start the appliance, press the ON/OFF
switch
and keep it pressed in .
The LED working light
ON/OFF switch
This provides illumination of the work area in
poor lighting conditions .
Switching off
♦
Release the ON/OFF switch
appliance .
Setting/preselecting the rotation
is
speed/tightening torque
♦
Press the torque preselection button
the required torque in stages .
♦
Press the ON/OFF switch
speed/tightening torque . Increasing the pres-
sure increases the speed/tightening torque .
■
The tightening torque depends on the selected
speed/torque preselection and impact duration .
into the
and remove the
.
as follows:
lights up when the
is depressed lightly or fully .
to switch off the
lightly for a low
GB │ IE
to
to select
│
7
■
Publicité
