Publicité
All manuals and user guides at all-guides.com
Introduction
Congratulations!
With your purchase you have decided in favour of a
quality product. Familiarise yourself with the product
before taking it into use. To do this, read the following
operating instructions attentively. Use the product only as
described and only for the specified areas of applica-
tion. Retain these instructions for future reference. In addi-
tion, pass these documents on, together with the product,
to any future owner.
Intended Use
The oil filter wrench PAWSO A1 is intended for the
loosening and tightening of oil filters fitted in automobiles.
Technical data
Length:
Width of steel band:
Using the oilfilter wrench
Note:
Oil changes are always to be carried out
at the motor operating temperature.
Precautionary measures for avoiding burns when
removing hot oil
When oil is being drained from a still hot engine,
all contact with the oil itself is to be avoided.
The new oil filter is to be filled up to 2/3 with fresh
oil and the rubber seal to be smeared with oil. This
smearing of the rubber seal facilitates later removal
of the oil filter and helps prevent damage to the
seal when tightening.
Screw the oil filter on hand-tight, then secure it
firmly with the oil filter key.
Important:
Observe without exception the
pertinent details given in the operating instructions
for your vehicle.
The oil filter can be exchanged after the oil has been
drained and the sump sealing screw replaced.
Place the oil filter key over the oilfilter and secure it
by turning the adjustment screw.
Loosen the oilfilter with the oil filter key, then remove
it by hand.
Important:
A residual amount of oil will escape
from the area of the filter mounting and filter. Ensure
that an oil pan is appropriately positioned.
PAWSO A1
215 mm
12 mm
GB │ IE │ NI
│
1
■
Publicité
