Witter HY19B Instructions De Montage

MATERIALS
A 1 Tubular Mainframe
B 1 Coupling Packer (25mm) – for use with Amica only
C 1 Centre Tube with international facing to 94/20/EC A50-1
D 4 M12 x 35mm x 1.25 Bolts, Lock Washers and Large Flat Washers (30mm O.D.)
E 2 M16 x 65mm x 2.00 Set Screws, Nuts and Lock Washers
CB 2 M16 x 50mm x 2.00 Coupling Bolts, Nuts, Lock Washers
2 M16 Bolt Caps for (E)
Z 1 ZEP35 Electrical Plate (not shown)
FITTING
1. Check that the captive nuts are in the chassis at (D). If the captive nuts are not present then the vehicle is not
type approved for towing. Note: it may be necessary to lower the exhaust mountings. On 2006 – models remove
centre bumper bracket and temporarily loosen two outer bumper brackets under vehicle.
2. Loosely attach Tubular Mainframe (A) to captive nuts in chassis using Bolts (D).
3. Attach Centre Tube (C) and tighten all bolts. Note: use 25mm coupling packer (B) for Amica only.
4. Refit exhaust and remount two outer bumper brackets.
This towbar must be used with either a Witter Towball (part number Z1) or Class A50-1 or A50-X towball dimensionally
Conforming to A50-1 with a 'D' and 'S' value greater than or equal to that of the towbar.
Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
Recommended torque settings: Grade 8.8 bolts: M8 - 24Nm, M10 - 52 Nm, M12 - 80 Nm, M14 - 130 Nm, M16 - 200
Nm Grade 10.9: M12 – 120Nm, M10 – 70Nm M8- 35Nm
WITTER TOWBARS
Deeside Ind. Park, Deeside, CH5 2NY
Fitting
Instructions
µW0001HY19B-FIT$011205160000oÄ
W0001HY19B-FIT$011205160000
For HYUNDAI ATOZ / AMICA
after chassis N
Note: Vehicles prior to this chassis number have
no captive nuts in the chassis and are not type
www.witter.towbars.co.uk
TOWBAR
o
109547(June 1998-
approved for towing
HY19B