Witter HY26A Instructions De Montage

Fitting
Instructions
MATERIALS
A 1 Tubular Crossbar with European facing to 94/20/EC – A50-1
C 4 M10x35x1.25mm Fine Pitch Bolts, Lock Washers and Washers (25mm O.D)
D 2 M10x35x1.25mm Fine Pitch Bolts, Lock Washers and Large Flat Washers (30mmO.D)
E 2 Spacers (3mm thick, use as required)
F 2 Exhaust Mounting Rubbers (Use as required)
CB 2 M16x50x2.0mm Coupling Bolts, Nuts and Lock Washers
FITTING
1. No need to remove or cut bumper. Remove the 3 screws retaining lashing eye to left chassis rail. Release
exhaust from two rearmost hangers and lower the spare wheel.
2. Remove the two innermost screws holding the bumper beam to chassis using 12mm socket (one on each side,
located near Bolts (C)).
3. Offer up Crossbar (A) and secure using Bolts (D). Insert one or both (1 each side) of Spacers (E) if or as
required between the vertical face of the vehicle frame and Tubular Crossbar (A) and attach using Bolts (C).
Tighten all Bolts.
4. Reattach the two rubber exhaust hangers. Note: It may be necessary to replace the rearmost rubber exhaust
hanging rubbers with the Exhaust Mounting Rubbers (F) provided to gain the necessary exhaust clearances on
some models.
5. Models with larger 215/65R15 spare wheels require the spare wheel cage mounting 30mm further forward using
one bolt either side.
Note: This towbar must be used with either a Witter Towball (part number Z11) or Class A50-1 or A50-X towball dimensionally
Conforming to A50-1 with a 'D' and 'S' value greater than or equal to that of the towbar.
Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
Recommended torque settings: M8 - 27Nm, M10 - 53 Nm, M12 - 95 Nm , M14 - 150 Nm, M16 - 214 Nm
WITTER TOWBARS Deeside Ind. Park, Deeside, CH5 2NY www.witter-towbars.co.uk
W0001HY26A-FIT$0112041100001Ä
W 0001HY26A-FIT$011204110000
TOWBAR
For HYUNDAI TRAJET
(May 2000 -)
HY26A