Witter HY57U Instructions De Montage

MATERIALS
A 1 Cross Bar
B 1 Left Side arm
C 1 Right Side arm
D 2 Large Spreader Plate
E 4 Small Spreader Plate
F 4 M10 x 35 x 1.25mm Fine Pitch Bolts and Lock Washers
G 4 M12 x 120 x 1.75mm Bolts, Nyloc Nuts and Flat Washers (30mm O.D.)
H 6 M12 x 35mm Bolts, Serrated Nuts
ZE 1 Electrical Plate (ZEP2)
ZQ 1 Neck (ZQ2070)
FITTING
1. Remove spare wheel, remove both rear silencers and remove both rear heat shields.
2. Unclip Fog lamp wiring from bumper crash beam and cut out four connecting plates as shown in photograph below.
3. Loosely attach sidearms (B) & (C) using fixings (F) & (G) with spreader plates (D) & (E) in position.
4. Insert Cross Bar (A) into crash beam and loosely attach to sidearms (B) & (C) using fixings (H). Tighten all bolts.
5. Cut exhaust heat shields to clear towbar side arms and re-fit. Re-fit exhaust silencers (Note: It is recommended that
the exhaust gaskets are replaced). Re-fit spare wheel.
6. Attach Neck (ZQ) and Electrical Plate (ZE) using fixings (X) as per separate instruction.
7. Fully Tighten all fixings.
Note:
Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
Recommended torque settings: M8 - 27Nm, M10 - 53 Nm, M12 - 95 Nm, M14 - 150 Nm, M16 - 214 Nm
WITTER TOWBARS
Deeside Ind. Park, Deeside, CH5 2NY
Fitting
Instructions
For Hyundai Santa Fe
Remove four connecting
plates by cutting at points
shown.
www.witter-towbars.co.uk
TOWBAR
HY57U
April 2006 -
Issue 1