Publicité
THE CONTROLS AND THEIR FUNCTIONS
ke
ТАРЕ Неа
TAPE
OUT —*
AUX IN
STEREO
OUT—
"STEREO
MONITOR
INSEAT
ОЛ
RECORDING
MIXER
MODEL
RM602
INPUT SECTION
1. INPUT SELECTOR
This four-position input selector sets the input sensitivity
of the six channel inputs to —50, -35 or —20 dB. Note
also that the fourth position on channels 1 —4 is labelled
"ТАРЕ", while the same position on channels Б and 6
are labelled "PHONO
Г" and "PHONO
В". When the
TAPE position on inputs 1—4 is selected, the corre-
sponding TAPE IN input (see rear panel) is selected as
input rather than the channel INPUT. When the PHONO
position on inputs 5 and/or 6 is selected, the correspon-
ding phono input channel (PHONO Г or PHONO
К) is
selected.
The -50/-35/-20 dB sensitivity positions on the input
selector allow you to match the input sensitivity of each
input channel to match the source
— e.g. microphone,
electronic music instruments or line level sources. This
allows you to use just about any source on any input
channel without overloading the mixer's electronics. Most
microphones
— especially dynamic types
— will work best
with the —50 dB input setting. Some high-output con-
denser and electret mics may require the —35 dB setting.
PRECAUTIONS
* Be sure to turn down all faders when making input/
output connections.
* Do not expose the RM602 to direct sunlight or other
sources of heat such as radiators, etc.
е Irreparable damage may result from opening the
RM602 cabinet or attempting to alter the internal
circuitry.
* Avoid dropping your RM602 or subjecting it to any
type of shock, as impaired performance may result.
е Do not attempt to clean the RM602 with benzine or
other soivents, as these may cause discoloration or
deformation of the cabinet. Clean the unit with a soft,
dry cloth.
-
Publicité
