Machine Description - Numatic WV 570 Mode D'emploi

This machine can be used for wet and dry pick up.
Dry Mode maintenance / fault finding
If the vacuum cleaner stops working switch off and remove the plug from the wall before
investigating were the fault lies.
If the vacuum cleaner will not pick up any debris from the surface, switch off and remove the plug from the wall,
inspect the floor tool, wands and hose for blockages, if no blockages are found, the dust bag may be full if the
dust bag is not full the filter may be blocked.
Wet mode / fault finding
If the vacuum cleaner stops working switch off and remove the plug from the wall before
investigating were the fault lies.
If the vacuum cleaner has a blockage and will not pick up liquid, switch off and remove the plug from the wall,
has the float valve operated, this will shut off the suction and the pitch of the vacuum motor will change Remove
the power head and empty the liquid out of the container, if the container is empty, check that the floor tool
wands and hose are not blocked.
After use always inspect the machine for damage.
We hereby declare under our sole responsibility that the
following equipment fulfils all the relevant provisions of the
following EU Directives:
Machinery Directive 2006/42/EC
EMC Directive 2014/30/EU
RoHS Directive 2011/65/EU

Machine Description:

Type: WVD, WV, CV, CVD series
Manufactured by:
Relevant standards upon which conformity is declared
include:
IEC 60335-1 2001 + A1 2004 + A2 2006 + National
Deviations
IEC 60335- 2-2 2002 + A1 +A2
IEC 60335-2.69 2002 + A2
EN 55014-1 2001 +A1 2001, +A2 2002
EN 55014-2 1997 + A1 2001 (Cat II)
EN 50366 2003 + A1 2006
A technical construction file for this equipment is retained at
the manufacturer's address under the authorisation of the
following signatory:
Name:Allyn Boyes
Signed:
EU DECLARATION
CONFORMITY
16
Numatic International Limited
Position: Technical Manager
Numatic International Limited,
Chard , Somerset.
TA20 2GB
www.numatic.co.uk
OF
Vacuum Cleaner
Date: 20/04/2016
GB
13