Publicité
Verify the work pieces / sheet will not move on the top support
bar
Make sure that you do not load workpieces unevenly. Otherwise,
the workpiece can become unbalanced and fall down.
Remove any excess materials on the product, e.g. wet paint, dirt, oil or snow.
When working, always use two trestles to hold the components / worktops.
Do not place a load on the product that protrudes over the side.
Do not use this multi-purpose trestle as a scaffold trestle.
Installation
Note: Make sure during assembly that the screws are only loosely tightened to
begin with. Tighten the screws fully only after you have completely assembled the
product.
First spread the leg of side frame
and lock the locking hook
the middle part of side frame
the hole on the side frame
be reminded to leave at least 3 holes to be protrude on top of the frame. Repeat
the above steps to have 2 side frames with support bar (Fig. A).
Make sure both hole bars
Connect the middle support bar
with both side frames
Use screw set
you finish connect screw set
hooks on the screw. Use the screw sets
steps to fix the middle support bar
Connect the bottom plate
fix both bottom plates in place (Fig. D).
Place the top support bar
the top support bar
Adjust the product correctly. Then retighten all screws.
Note: it is necessary to fasten the supporting struts
ensure that the torsional rigidity of the axle stand is good.
Raise the two safety brackets
Use
CAUTION! RISK OF INJURY! Be sure locking hooks
secured in place. Also ensure that both trestles are always at the same height.
This is the only way to ensure stability.
Always use two trestles and a board or boards together for working.
8
GB/IE/NI
. If necessary, secure in place.
8
on the other leg. Insert the hole bar
12
. Use the locking pin
5
in order to lock the hole bar
5
are on the same height.
7
9
(Fig. B).
5
on the side where is the locking hook
2
, pull down the locking hook
2
to the leg with screw set
6
onto the hole bar
8
in place (Fig. E).
8
on the top support bar
13
. Pull down the locking pin
5
and use screw sets
on the other side. Repeat the above
1
in place (Fig. C).
9
. Use screw sets
7
6
on the leg
10
through
7
and insert through
10
in place. Please
7
and
to connect
1
2
on the leg. After
11
and lock the
11
. Repeat the above to
3
to fix
4
tightly to the legs to
(Fig. F).
8
und
are
11
12
Publicité
