Warming Up; Stopping The Engine - EuroGarden HFX600DT-DELUX Manuel Du Propriétaire

HFX600DT-DELUX,750DT-DELUX ·
HF600DT-PRO,750DT-PRO ·
HF580DT-L,750DT-L
A
B
HF750FS-PRO · H550S,750S
A
B
A. Lift Up Lever
(Running Position)
B. Throttle Lever
After starting, run the engine at the idling speed for a few
minutes. (See Warming up)
NOTE
○
The lift up lever will automatically return to the "RUNNING/
IDLING" position when the operator moves the throttle lever
momently.
○
After starting, vary the engine speed a few times, by
operating the throttle lever to draw out the remaining air in
the carburetor.

Warming Up

●
After starting the engine, run the engine at the idling speed
(throttle lever position is fully CLOSED) for a few minutes.
NOTICE
Allow sufficient warm-up time to prevent engine damage
and run the engine smoothly. The engine should be
run at idle speed for a few minutes to allow it to warm
up before applying a load. This will allow oil to reach
engine parts, and allow piston clearance to reach design
specifications.
Adjustment of the idling speed
A B
A. Idle Screw
B. Lift Up Lever
The stable idling speed is about 3,000 rpm.
Fuel Adjustment
The carburetor has been adjusted to the optimum fuel supply at
the factory.
Don't reset the carburetor setting.
NOTE
○
If adjustment is needed, it should be performed by your
authorized equipment dealer.
10
●
Once squeeze the throttle
lever to switch the lift up lever
to RUNNING (idling) position,
and then release the throttle
lever back to fully CLOSED
position.
●
If the cutting blades move
when the engine is running
at the idle speed, turn the
idle screw counterclockwise
to decrease the engine idle
speed.
●
If the engine does not run the
idle speed, it may be changed
too low. Turn the idle screw
clockwise to increase the
engine idle speed.

Stopping the Engine

NOTICE
Suddenly stopping engine from high-speed operation
can cause engine damage. Reduce engine speed to idle
speed for one minute before shutting engine off after
high-speed, full-load operation.
Ordinary Stop
HFX600DT-DELUX,750DT-DELUX ·
HF600DT-PRO,750DT-PRO ·
HF580DT-L,750DT-L
A
C
B
HF750FS-PRO · H550S,750S
C
A
B
A. Engine Switch
B. Throttle Lever
C. Set Lever
Emergency Stop
●
Turn the engine switch to the "O" position.
NOTE
○
Never stop the engine during operation while running above
idle speed.
●
Shut off the engine and allow it to cool before transporting or
storing the unit.
●
Do not put the unit on dry grass or near any flammable object
unless the engine is cold or cooled down.
●
Place the hedge trimmer on
firm ground.
●
Turn the throttle lever to the
"RUNNING/IDLING" position,
and run the engine at the idling
speed.
●
Turn the engine switch to the
"O" position.