Correct Posture - Beurer medical BM 44 Mode D'emploi

Important: The instrument should only be operated with the
original cuff. The cuff is suitable for an arm circumference of
22 to 30 cm.
A larger cuff for upper arm circumferences from 30 to 42 cm
is available from retailers or the service address under order
no. 162.795.

Correct posture

Rest for approx. 5 minutes before each measurement.
Otherwise there may be divergences.
You can perform the measurement either sitting or lying
down. Always make sure that the cuff is on a level with
your heart.
To carry out a blood pressure measurement, make sure
you are sitting comfortably with your arms and back lean-
ing on something. Do not cross your legs. Place your feet
flat on the ground.
In order not to distort the result, it is important to keep still
during the measurement and not talk.
Measuring blood pressure
Switch on the blood pressure monitor with the start/stop
button .
Before the measurement, the last saved test result is brief-
ly displayed. If there is no measurement in the memory,
the instrument always displays the value .
The cuff automatically inflates. Cuff air pressure is re-
leased slowly.
If a tendency towards high blood pressure is already
detectable, the cuff is pumped up again and cuff pressure
increased further. As soon as a heart rate is detected, the
heart rate symbol
Heart rate, systolic and diastolic blood pressure are dis-
played.
You can interrupt measurement at any time by pressing
the start/stop button
_ appears if it has not been possible to perform the
measurement properly. Observe the section in these in-
structions on error messages/troubleshooting and repeat
the measurement.
The test result is saved automatically.
To switch off and release the pressure, press the start/
stop button again. If you forget to switch off the device,
it switches off automatically after approx. 1 minute.
Wait at least 5 minutes before taking another measurement!
20
is displayed.
.