Publicité
˜ Installation (see fig. A–C)
Place the product upside down on a soft
underlay to avoid scratch on the surface,
power cord retainer
temperature control
Attach the U shape bolt
between first two fins with the threaded ends
pointing upward (see fig . A) .
Place the U shape castor assembly
over the U shape bolt
pointing upward (see fig . B) . Ensure both
threaded ends of U shape bolt
through both holes on the U shape castor
assembly
.
11 ]
[
Fasten wing nut
[
8 ]
threaded end of U shape bolt
Repeat above steps on the rear side of the
product with the I shape castor assembly
and the U shape bolt
last two fins (see fig . C) .
Set the product back to upright position,
wheels on the floor . It is now ready to use .
NOTE: The product is equipped with a
tilt protection switch . It will shut down the
product automatically if it falls over or is
lying on its side .
˜ Operation
Unwind the power cord completely from the
power cord retainer
Make sure that both, temperature control
and heat level switch
"0" respectively .
24 GB/IE
upper than
7 ]
[
(see fig . A) .
3 ]
[
to the product
[
10 ]
[
11 ]
with both wheels
10 ]
[
passing
10 ]
[
securely onto each
.
10 ]
[
9 ]
[
attached between
[
10 ]
.
[
7 ]
3 ]
[
are set to and
[
2 ]
Connect the product to a grounded mains
socket protected by a residual current circuit
breaker . Ensure that the mains voltage of
the electrical outlet meets the requirements
described in the "Technical data" chapter .
NOTE: Ensure the mains plug is fully
inserted to the mains socket .
˜ Reaching the decided
room temperature
Set the temperature control
heat level switch
[
2 ]
When the desired room temperature is
reached, turn the temperature control
gently counter-clockwise until the product
shuts off . A "click" sound is emitted . Leave
the temperature control
and the room temperature is now retained .
The product automatically cycles on and off
to keep the desired room temperature .
Use the heat level switch
quickly the product shall warm up . To warm
up quickly, set the heat level switch
"3" .
NOTES:
The power indicator
heat level switch
2 ]
[
or "3" .
The power indicator
heat level switch
2 ]
[
to and the
[
3 ]
to "3" .
[
3 ]
at the position
3 ]
[
to select how
2 ]
[
to
[
2 ]
lights up when the
[
1 ]
is turned to "1", "2"
goes off when the
[
1 ]
is turned to "0" .
Publicité
