Publicité
EN
6.2 WORKING CYCLE EX-
AMPLE
Setting a washing cycle with brushes and
drying.
-
Press the switch (47) to enable the rota-
tion of the brush and the water supply.
-
Press the switch (46) to start the vacuum
cleaner.
7.1 FILLING THE TANK
(Fig. 11
WARNING:
Only add clean mains water to the tank at
a temperature no greater than 50°C.
-
Remove the hose (26) supplied, connect
one end (31) to a tap and insert the other
end (52) in the tank (5).
-
Check that the tap (53) is open.
-
Turn on the tap and fill the tank (5).
-
The level of water contained in the tank is
displayed on the transparent tube (15).
-
Pour the detergent fluid in the tank.
NOTE:
Use non-foamy detergents only. For the
quantities, follow the instructions provided by
the detergent manufacturer according to the
type of dirt.
DANGER:
If the detergent comes in contact with the
eyes and/or skin or if swallowed, refer to
the use and safety information booklet
provided by the manufacturer of the de-
tergent.
8.1 OPERATION (Fig. 1)
8.1.a - Checks before use
-
Check that the exhaust tube (12) of the
recovery tank is properly coupled and
properly sealed.
-
Check that the connector (54) on the
squeegee (11) is not blocked and that the
(Fig. 9)
)
EN-8
hose is connected correctly.
-
Check that the clean water exhaust tube
(15) is correctly coupled to the supports
and that the tap (53) is open.
-
Press the switch (45) and check the bat-
tery charge on the indicator discharge
(48).
8.1.b - Preparing the machine and
choosing the cycle (Fig. 9-12)
-
Press the switch (45 Fig.9) in position "I".
-
Release the lever (3 Fig. 12) and lower
it; the floor squeegee (11 Fig. 12) is low-
ered.
-
Press the pedal (19 Fig. 12), detach it
from the clamp, and lift it, the brush (10
Fig. 12) is lowered.
Working cycle:
-
The machine can perform 4 working cy-
cles:
Drying only cycle:
-
To run the drying cycle press the switch
(46 Fig. 9), you start the vacuum cleaner.
Brushing only cycle:
-
To make only the brushing cycle press
the switch (47 Fig. 9) to enable the rota-
tion of the brush. Press the control loca-
ted on the handle to start the rotation of
the brush.
Washing, brushing cycle:
-
Press the button (47 Fig. 9) to enable the
rotation of the brush
Press the control, positioned on the han-
dle, to start the rotation of the brush.
Washing, brushing, drying cycle:
-
Press the switch (46 Fig. 9) to start the
vacuum cleaner, the button (47 Fig. 9) to
enable the rotation of the brush and the
water supply.
Press the control on the handle to start
the rotation of the brush and the water
supply.
Publicité
