Publicité
EN
PROBLEM
Pressing the switch (45)
"
", the machine does not
work.
The brush does not rotate.
Aspirator does not work.
The machine does not dry
well, leaving traces of water
on the floor.
TROUBLESHOOTING
CAUSE
Low battery.
Main fuse blown.
The battery's plug is still lo-
cated in the charger's outlet.
Function card damaged.
The touch sensor on the
handle is defective.
Brush motor damaged.
Brush switch not pressed or
failure.
Function card damaged.
Intake motor damaged.
Vacuum switch not pressed
or failure.
Recovery tank full.
Aspirator off.
Aspiration tube blocked.
Dirty wiper.
Recovery tank full.
Dirty water filter clogged.
Squeegee
rubber
worn.
EN-14
SOLUTION
Check that the battery is
charged.
Replace the main 50A or 75A fuse.
Place the plug correctly.
Replace.
Replace.
Replace.
Press the appropriate switch
or replace it.
Replace.
Replace.
Press the appropriate switch
or replace it.
Empty, wash and clean the
tank.
Start up the aspirator.
Check
and
clean the aspiration tube that
connects the squeegee to
the recovery tank.
Clean the wiper.
Empty the recovery tank.
Clean the filter.
blades
Replace or turn over the
squeegee rubber blades.
if
necessary
Publicité
