Publicité
LED Work Light (Fig. 7)
Your tool is equipped with an LED work light,
located in front of the tool. This provides
additional illumination of the surface of the
workpiece.
The LED work light will automatically turn on
with a slight squeeze on the variable-speed
trigger switch before the tool starts running,
and will turn off approximately 10 seconds after
the variable-speed trigger switch is released.
The LED work light will rapidly flash when the
tool and/or battery pack becomes overloaded
or too hot, and the internal sensors will turn the
tool off. Rest the tool for a while or place the
tool and battery pack separately under air flow
to cool them.
The LED work light will flash more slowly to indicate that the battery pack is at low-battery
capacity. Recharge the battery pack.
Installing and Removing Bits
WARNING
damaged shanks .
The tool is designed to quickly switch between drilling and screw-driving by having a drill bit
inserted into one collet and a screw-driving bit into the other. Example: drilling a pilot hole with
one bit and then immediately driving a screw with the other.
Lock the variable-speed trigger switch "OFF" by placing the direction-of-rotation selector in the
center position.
To install a 1/4" Hex SCREW-DRIVING bit
(Fig . 8a)
Pull the sleeve of the collet forward (away from
the tool), insert the bit directly as far as it will go
into the collet. Release the sleeve and check to
make sure that the bit is firmly in place.
To install a 1/4" Hex DRILL bit
Push the head flip release button to the bottom
and flip the head 180° until you hear a "click"
sound (Fig. 8b). Insert a 1/4" hex DRILL bit into
the other collet (Fig. 8c) the same way as the
SCREW DRIVING bit.
Use only bits with power grooves. Other bits can be used with a
universal bit holder that has power groove. Do not use bits with
Fig . 7
LED Work Light
Fig . 8a
b
c
a
15
Publicité
