Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
LS10.0E, LS13.0E ASSEMBLY STEP 7
WATER
LS10.0E
BOTTLE
LS13.0E
HOLDER
CONSOLE
MAST
BOOT
TOP CAP
(LEFT & RIGHT)
SCREWS (Z)
REAR CAP
SCREWS (Z)
REAR STABILIZER
16
LS8-LS10-LS13E-OM_Rev1.3.indd 16-17
HARDWARE BAG 7 CONTENTS :
LS10.0E SHOWN
SCREW (Z)
SCREW (AA)
15 mm
20 mm
Qty: 5
Qty: 2
CONSOLE MAST
* This step is for LS10.0E, LS13.0E models only.
SCREWS (AA)
Open hardware bag 7.
A
Slide right and left top cap over
B
console mast and attach using 3
screws (z).
C
Slide console mast boot around
console mast and insert into top cap.
Slide water bottle holder over
D
console mast and attach using 2
screws (aa).
Slide rear cap over rear stabilizer
E
and attach using 2 screws (z).
ASSEMBLY STEP 8
LS10.0E SHOWN
CONSOLE
CONSOLE CABLES
UPPER HANDLEBAR
BOLTS (BB)
PRE-INSTALLED
SET SCREWS
CONSOLE MAST
LOWER HANDLEBAR
NOTE: Be careful not to pinch
any wires while attaching the
console or handlebars.
HARDWARE BAG 8 CONTENTS :
BOLT (BB)
12 mm
Qty: 4
A
Open hardware bag 8.
B
Attach the CONSOLE CABLES to the CONSOLE.
C
Carefully tuck the CONSOLE CABLES into the
CONSOLE MAST before attaching the CONSOLE.
Attach CONSOLE to CONSOLE MAST using 4
BOLTS (BB).
D
Slide UPPER HANDLEBAR onto LOWER
HANDLEBAR making sure handlebars are joined
together completely. Secure UPPER HANDLEBAR
to LOWER HANDLEBAR using PRE-ATTACHED
SET SCREWS.
Make sure upper handlebars are as far down as possible.
Handlebars can be damaged If not secured correctly.
E
Repeat step D on other side.
LS8.0E, LS10.0E ASSEMBLY COMPLETE!
7/22/10 1:48 PM
ALL
MODELS
17
Publicité
Table des Matières
