Livestrong LS8.0E Manuel Du Propriétaire page 6

LS10.0E, LS13.0E ASSEMBLY STEP 2
HARDWARE BAG 2 CONTENTS
LS10.0E
FLAT WASHER (D) SPRING WASHER (E)
LS13.0E 20 mm 18 mm
Qty: 4 Qty: 4
FLAT WASHER (H) SPRING WASHER (I)
16 mm 15 mm
Qty: 4 Qty: 4
LS10.0E, LS13.0E SHOWN
BOLTS (F)
SPRING WASHERS (E)
FLAT WASHERS (D)
NUTS (J)
SPRING WASHERS (I)
FLAT WASHERS (H)
GUIDE RAIL SET
10
LS8-LS10-LS13E-OM_Rev1.3.indd 10-11
* This step is for LS10.0E, LS13.0E models only.
Open hardware bag 2.
BOLT (F) BOLT (G) A
20 mm 35 mm
Qty: 4 Qty: 4
Attach the guide rail set to the
B
main frame using 4 bolts (f), 4
NUT (J)
spring washers (e) and 4 flat
Qty: 4
washers (d).
Attach the guide rail set to the
C
main frame using 4 bolts (g),
4 flat washers (h), 4 spring
washers (i) and 4 nuts (J).
MAIN FRAME
BOLTS (G)
ASSEMBLY STEP 3
LS10.0E SHOWN
CONSOLE MAST
CONSOLE CABLE
PRE-INSTALLED BOLTS
MAIN FRAME
NOTE: Be
careful not
to pinch any
wires while
attaching the
console mast.
CRANK
PEDAL ARM
WAVY WASHER (L)
FLAT WASHER (K)
GUIDE RAIL
SPRING WASHER (B)
PEDAL ARM WHEEL
BOLT (M)
HARDWARE BAG 3 CONTENTS :
WAVY WASHER (L) BOLT (M) SPRING WASHER (B) FLAT WASHER (K)
22.5 mm 20 mm 15 mm 20 mm
Qty: 2 Qty: 2 Qty: 2 Qty: 2
Open hardware bag 3.
A
Carefully pull the console cable through
B
the console mast using the twist tie located
inside the console mast.
C gently slide the console mast onto the
main frame and attach console mast to
main frame using pre-installed bolts.
Slide wavy washer (l) over crank
D
followed by pedal arm as shown. Rest
pedal arm wheel on guide rail.
Attach the pedal arm to the crank using 1
E
flat washer (k), 1 spring washer (b)
and 1 bolt (m).
Repeat steps D–E on the opposite side of the
F
elliptical.
7/22/10 1:48 PM
ALL
MODELS
11