Livestrong LS8.0E Manuel Du Propriétaire page 8

ASSEMBLY STEP 6
ALL
MODELS
LOWER LINK ARM
TEFLON WASHERS (V)
14
LS8-LS10-LS13E-OM_Rev1.3.indd 14-15
HARDWARE BAG 6 CONTENTS :
LS10.0E SHOWN
TEFLON FLAT WASHER (W)
WASHER (V)
17 mm
28.4 mm Qty: 2
Qty: 4
Open hardware bag 6.
A
Align end of lower link arm with bracket on
B
bottom of lower handlebar.
Place teflon washers (v) on both sides of
C
the lower link arm. While holding teflon
NUT (Y)
washers (v) slide lower link arm into
LOWER HANDLEBAR
bottom end of lower handlebar.
FLAT WASHER (W)
Secure the joint with 1 flat washer (w), 1
D
SPRING WASHER (B)
spring washer (b),1 bolt (X) and secure
BOLT (X)
with 1 nut (y).
Repeat steps B–D on the opposite side of the
E
elliptical.
LS8.0E ASSEMBLY STEP 7
WATER
SPRING WASHER (B)
BOTTLE
15 mm
HOLDER
Qty: 2
BOLT (X) NUT (Y)
70 mm Qty: 2
Qty: 2
SCREWS (AA)
CONSOLE
MAST BOOT
TOP CAP
SCREWS (Z)
REAR CAP
LS8.0E SHOWN
CONSOLE MAST
* This step is for LS8.0E only.
TOP CAP
REAR
COVER
Open hardware bag 7.
A
Slide top cap and top cap rear cover
B
over console mast and snap into place.
Insert console mast boot over top cap
C
and snap into place.
Slide water bottle holder over
D
console mast and attach using 2
screws (aa).
Slide rear cap over rear stabilizer and
E
attach using 2 screws (z).
NOTE: Be careful not to pinch any
wires while tightening screws.
REAR STABILIZER
HARDWARE BAG 7 CONTENTS :
SCREW (Z) SCREW (AA)
LS8.0E
15 mm 20 mm
Qty: 2 Qty: 2
15
7/22/10 1:48 PM