Chamberlain LiftMaster PROFESSIONAL SECURITY+ 3255-2CM Manuel Du Propriétaire page 31

PROGRAMMING
NOTICE: If this Security✚
the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security✚
To Add or Reprogram a Hand-held Remote Control
USING THE "LEARN" BUTTON
1. Press and release the "learn" button
on the motor unit. The learn indicator
light will glow steadily for 30 seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote* that
you wish to operate your garage door.
3. Release the button when the motor
unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.
To Erase All Codes From Motor Unit
Memory
To deactivate any unwanted remote, first
erase all codes:
Press and hold the "learn" button on motor
unit until the learn indicator light goes out
(approximately 6 seconds). All previous
codes are now erased. Reprogram each remote or keyless
entry you wish to use.
® garage door opener is operated with a non-rolling code transmitter, the technical measure in
USING THE MULTI-FUNCTION DOOR CONTROL
1. Press and hold the button on the
hand-held remote* that you wish to
operate your garage door.
2. While holding the remote button, press
and hold the LIGHT button on the
Multi-Function Door Control.
3. Continue holding both buttons while
you press the push bar on the
Multi-Function Door Control (all three
buttons are held).
4. Release buttons when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.
*3-Button Remotes
If provided with your
garage door opener, the
large button is factory
programmed to operate it.
Additional buttons on any
Security✚ ® 3-Button remote
or compact remote can be
programmed to operate
other Security✚ ® garage door openers.
31
remote controls.
®