emerio PAC-125216.3 Mode D'emploi page 10

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Drying mode
The fan runs at a low speed. The fan speed and temperature cannot be adjusted.
The compressor will stop after 8 minutes of running and then run again after 6 minutes.
Cooling mode
When the room temperature is higher than the set temperature, the compressor starts to run.
When the room temperature is lower than the set temperature, the compressor stops and the fan
operates at the original set speed.
Note: When the compressor is working, the unit will vibrate slightly. This is normal and harmless.
Fan mode
When the fan runs at the set speed, the compressor does not run.
The adjustment of temperature in Fan mode is not effective.
5. Timer button
Auto-ON setting
When the appliance is OFF, press the timer button, the timer indicator light will flash.
-
Press the timer increasing or decreasing button to select a desired auto-ON time from 1 to 24 hours.
-
The digital display and timer indicator light will flash for several seconds, then the timer setting is
confirmed and the timer indicator light will illuminate still.
The appliance will automatically turn on once the select time passed.
-
Auto-OFF setting
When the appliance is ON, press the timer button, the timer indicator light will flash.
-
Press the timer increasing or decreasing button to select a desired auto-OFF time from 1 to 24 hours.
-
The digital display and timer indicator light will flash for several seconds, then the timer setting is
confirmed and the timer indicator light will illuminate still.
The appliance will automatically turn off once the select time has passed.
-
To cancel the timer, set the time to 0 hour, or press into the timer setting, and when the digital display flashes,
press the timer button again. The timer indicator light will then turn off.
6. Sleep button (only active in cooling mode)
Press the sleep button to activate the sleep mode. The sleep indicator light turns on.
In sleep mode, the fan turns to low speed automatically. The set temperature will increase 1 ℃ after
one hour, and increase 2 ℃ after two hours. After six hours, the appliance stops running automatically.
NOTE:
The protective device may trip and stop the appliance in the conditions listed below.
Cooling
Drying
If the appliance runs in cooling or drying mode with door or window opened for a long time when
relative humidity is above 80%, dew may drip down from the air outlet.
Drain water
1) Special reminder: There is condensing water recycling hidden in this appliance. The condensing water is
partly kept recycling between the condenser and the water tray. When the water level rises to the upper
level, the water-full code "E4" will be shown on the digital display to remind of draining water.
Room temperature is over 43℃.
Room temperature is below 15℃.
Room temperature is below 15℃.
- 9 -

Publicité

Table des Matières
loading

Table des Matières