Product Description - Abicor Binzel ABIPLAS CUT Mode D'emploi

®
ABIPLAS CUT
Type
Type of use
Pilot current
Rated current and
corresponding duty cycle
Type of gas
Gas flow rate
Operating pressure
(flow pressure)
Torch inlet pressure [bar]
Air flow rate measured
Plasma air [l/min]
Soft start air [l/min]
Air post-flow time [s]
Selection of plasma
nozzle
Product-specific torch data (EN 60 974-7)
Tab. 4
®
ABIPLAS CUT 70
®
ABIPLAS CUT MT 70
15 - 22A (max. 25A)
70A / 60%
50A / 100%
approx. 155 l/min
with nozzle bore
1.1 mm
approx. 22
≥ 12
0.9 mm / to 30A
1.1 mm / to 30 - 60A
1.2 mm / to 50 - 70A
1.1 mm long/max. 50A 1.2 mm long/max. 50A 1.2 mm long/max. 50A
The specifications on the cutting capacity are standard values only, which are
also greatly affected by the following items.
• Type and quality of the material
• Pressure and impurities of the compressed air
• Temperature of the work-piece to be cut
• Desired cutting quality
• Condition of electrode and cutting nozzle
• Distance and position of the cutting torch from work-piece
• Power sources - Characteristic
• Cutting speed
®
ABIPLAS CUT 110
®
ABIPLAS CUT MT 110
manual/automatic
15 - 25A (max. 27A)
110A / 60%
90A / 100%
Compressed air
approx. 180 l/min
5 - 5,5
with nozzle bore
1.4 mm
approx. 30
≥ 15
60
1.0 mm / to 30 - 50A
1.2 mm / to 40 - 70A
1.4 mm / to 70 - 90A
1.6 mm / to 90 - 110A
2.6 mm for gouging

2 Product Description

®
ABIPLAS CUT 150
®
ABIPLAS CUT MT 150
15 - 27A (max. 29A)
150A / 60%
120A / 100%
approx. 235 l/min
with nozzle bore 1.8 mm
approx. 39
≥ 15
1.2 mm / to 70A
1.5 mm / to 70 - 90A
1.6 mm / to 90 - 120A
1.8 mm / to 120 - 150A
3.0 mm for gouging
EN - 5