Publicité
Recommended detergents
Usage
Maintenance cleaning of all water-re-
sistant floors
Maintenance cleaning of polished
hard surfaces (e.g. granite)
Maintenance cleaning, intermediate
cleaning and basic cleaning of indus-
trial floors
Maintenance cleaning and basic
cleaning of fine stone tiles
Maintenance cleaning of tiles in sani-
tary areas
Coating removal on all alkaline-resis-
tant floors (e.g. PVC)
Coating removal on linoleum floors
Fill in detergent with dosing device
Only variant DOSE:
Detergent is added to the fresh water on its way to the
cleaning head by a dosing device.
1. Unlock the waste water tank and swing it backwards.
2. Fill the detergent canister with detergent.
3. Swivel the waste water tank forward.
Note
A maximum of 3% detergent can be added with the dosing
device. For higher dosage, the detergent must be added to
the fresh water tank.
Filling the detergent into the fresh water tank
1. Fill the detergent into the fresh water tank.
Note: The cap of the fresh water tank filling hole can be
used for measuring the detergent. It is fitted with a scale
on the inside.
Adjusting parameters
1. Set the program switch to the desired cleaning program.
2. Turn the Info button until the desired parameter is dis-
played.
3. Press the Info button.
The adjusted value flashes.
4. Set the desired value by turning the Info button.
5. Confirm the changed setting by pressing the Info button
or wait until the set value is automatically accepted after
10 seconds.
Yellow Intelligent Key
The yellow Intelligent Key authorizes functions that are re-
quired for the cleaning task.
The parameters for the various cleaning programs are pre-
set in the device. Individual parameters can be changed
depending on the authorization of the yellow Intelligent
Key.
The display texts for parameter settings are largely self-ex-
planatory.
"FACT" parameters (only available with R cleaning head):
● "Fine Clean": Low brush speed for removing gray film
from fine stone.
● "Whisper Clean": Medium brush speed for maintenance
cleaning with reduced noise level.
● "Power Clean": High brush speed for polishing, crystal-
lizing and sweeping.
16
Detergent
The inclination must be adjusted so that the suction lips of
RM 746
the suction bar make even contact with the floor over the
RM 756
entire length of the suction bar.
RM 780
1. Park the device on a surface without a slope.
RM 755 es
2. Turn the program switch to the "Vacuum" position.
3. Drive the device a small distance forwards.
RM 69 ASF
4. Read the spirit level.
RM 753
RM 751
RM 752
RM 754
1
2
3
5. Unscrew the nut.
6. Adjust the screw so that the spirit level indicator is be-
7. Tighten the nut.
8. To check the new setting, move the device forward
9. Turn the program switch to "OFF".
The height adjustment affects the bending of the suction
lips on contact with the floor.
Note
Standard setting: 3 washers above, 3 washers below the
suction bar.
Uneven floor: 5 washers above, 1 washer below the suction
bar.
Very smooth floor: 1 washer above, 5 washers below the
suction bar.
1. Unscrew the nuts.
1
2
´
3
English
Adjusting the suction bar
Adjusting the inclination
Screw
Nut
Spirit level
tween the two lines.
again a short distance. Repeat the adjustment process
if necessary.
Adjusting the height
Nut
Washer
Spacer roller with holder
Publicité
