Publicité
Cleaning and maintenance
Integrated cleaning programme
The integrated cleaning programme (takes
about 15 minutes) removes residues and
coffee oil residues that cannot be removed
by hand. The cleaning symbol
during the entire process.
The cleaning programme should be
performed every 2 months or after 200
brewed cups, however, at the latest when
is illuminated.
■ Before starting the cleaning programme,
clean the brewing group and the
interior ("Cleaning the brewing unit",
page 21).
Only use Melitta
cleaning tabs.
■ Switch off the device.
■ Fill the water tank with tap water up to
the max. mark.
■ Insert the water tank.
■ Press the
simultaneously for approx. 3 seconds.
fl ashes,
■ Empty the drip tray and coffee grounds
container.
■ Insert the drip tray without the coffee
grounds container
■ Place the coffee grounds container
under outlet 2.
Cleaning phase 1 (
Two rinsing processes will be executed.
When
illuminates, proceed as follows:
■ Remove the brewing unit.
■ Put a cleaning tab in the brewing unit
(Image C).
■ Insert the brewing unit.
22
fl ashes
PERFECT CLEAN
®
and
buttons
illuminates.
):
Operating Instructions: Melitta
Cleaning phase 2 (
When
illuminates, proceed as follows:
■ Fill the water tank with tap water up to
the max. mark.
■ Press outlet 2 all the way down.
■ Press the
button to continue with
the cleaning programme (takes about
5 minutes).
Cleaning phase 3 (
When
illuminates, proceed as follows:
■ Empty the drip tray and coffee grounds
container.
■ Insert the drip tray without the coffee
grounds container
■ Place the coffee grounds container
under outlet 2.
Cleaning phase 4 (
bean is fl ashing):
■ The cleaning programme will be
continued again and takes about
5 minutes.
When
illuminates, proceed as follows:
■ Empty the drip tray and coffee grounds
container and insert them in the
appliance as usual.
The cleaning programme is fi nished.
Solo
®
®
):
):
, the middle
| 1828-0618 | 2018-08
Publicité
