EcoSmart Fire Base 30 Manuel D'installation page 171

Burner Assembly - Propane
19. Ensure propane tank is in the OFF position. Attach propane hose
and included regulator to propane tank.
OFF
19.Ensure propane tank is in the OFF position. Attach propane hose and included regulator to propane tank.
20. Ensure the control knob (or "key") is in the OFF position.
21. Use a leak detecting solution to check all connections before
operation.
22. Slowly open main gas supply shut-off valve and check for any
bubbles on inlet side of gas system. If bubbles are present, close main
gas supply shut-off valve immediately and tighten all fittings again using
adjustable wrenches.
23. If no leaks are present, a first lighting and final leak check can be
performed.
24. With main gas supply shut-off valve open, turn control valve to LOW/
IGNITION position. Press and hold sparker button, slowly depress
control knob and hold in for 3-5 seconds. Burner should be ignited.
Verify no bubbles are present on outlet side of gas system.
25. If no leaks are present on outlet side of gas system, the burner is
ready for normal operation. If leaks are present, turn control valve to the
OFF position and close main gas supply shut-off valve. Re-tighten all
fittings and repeat 24.
Adequate and constant ventilation is important to keep the appliance
functioning properly and safely, including ventilation of the appliance
undersides. Setting the appliance without air circulation underneath
can cause heat build up and improper combustion. Do not remove
the feet or operate the appliance with missing feet.
1. Locate the appliance and the LP tank cover on hard, flat surface
that extends the full length and width of the appliance. The
appliance and the LP tank cover can be placed on combustible
surface (such as wood deck) or on non-combustible material (such
as concrete). Ensure all clearances to the sides and clearances
above the appliance are observed at all times (see figures 1 and 2).
2. Maintain a minimum air space of ½" (12.5mm) between the ground
surface and the underside of the appliance sidewalls by adjusting
the articulating feet up or down as necessary.
3. Do not place the appliance over grass, artificial turf, carpet or
any uneven surface, as this will block the airflow underneath the
appliance. See figure 1.
4. Follow the same instructions above for the LP tank cover (if
purchased). See figure 1.
Min 0.5''
CORRECT
(12.5mm)
CORRECT
Min 0.5''
(12.5mm)
Figure 1
WARNING
Do not burn without black glass charcoal on burner.
© Copyright 2004 - 2021 EcoSmart Inc. All rights reserved. 0721
13
INCORRECT
INCORRECT