EcoSmart Fire Base 30 Manuel D'installation page 163

Clearances
When planning an appliance installation, it's necessary to determine
the following information first:
Environmental Conditions
WARNING: Ensure that your fire is positioned away from flammable
materials and other sources of ignition (combustible materials,
gasoline and other flammable vapors and liquids) at all times. Pay
very close attention to positioning the fire away from items that may
move as a result of wind and drafts. For example trees/branches/
curtains/paper and the like.
The base of the burner within the model must never come into direct
contact with flammable materials.
Locating your appliance
Adequate and constant ventilation is important to keep the appliance
functioning properly and safely, including ventilation of the appliance
undersides. Setting the appliance without air circulation underneath
can cause heat build up and improper combustion. Do not remove
the feet or operate the appliance with missing feet.
1. Locate the appliance and the LP tank cover on hard, flat surface
that extends the full length and width of the appliance. The
appliance and the LP tank cover can be placed on combustible
surface (such as wood deck) or on non-combustible material (such
as concrete). Ensure all clearances to the sides and clearances
above the appliance are observed at all times (see figures 1 and 2).
2. Maintain a minimum air space of ½" (12.5mm) between the ground
surface and the underside of the appliance sidewalls by adjusting
the articulating feet up or down as necessary.
3. Do not place the appliance over grass, artificial turf, carpet or
any uneven surface, as this will block the airflow underneath the
appliance. See figure 1.
4. Follow the same instructions above for the LP tank cover (if
purchased). See figure 1.
Min 0.5''
CORRECT
(12.5mm)
CORRECT
Min 0.5''
(12.5mm)
Figure 1
Position the appliance adjacent to the gas supply line or LP gas
supply cylinder.
DO NOT locate the appliance where it will get excessively wet or
submerged in water.
Minimum Clearances
Note: Measurements are distances closest to the flame
Side clearances to fixed and stable furniture items that are not
susceptible to movement such as lounges or patio furniture must remain
a minimum of 24in (610mm) away from the flame at all times.
INCORRECT
INCORRECT
Overhead clearances to items that are susceptible to movement
(e.g. Curtains/Trees) must remain a minimum of:
- 78.7in (2000mm) away from the flame at all times.
Ceiling clearances must remain a minimum of:
- 72in (1,829mm) to overhang from top of burner.
Please note that:
Any furniture items or fittings directly above or beside the Burner
installation must be deemed suitable for heat tolerances by
their manufacturer e.g. electronic items including screens and
entertainment equipment, wallpaper, laminates, veneers, glues and
reconstituted materials.
MAD Design USA is not liable for any injuries or damages sustained
through any installation not in compliance with this manual.
A fire extinguisher is strongly recommended.
WARNING
MAD Design USA disclaims any responsibility for, and the
warranty will be voided by, the following actions:
• Installation and use of any damaged components.
• Modification of the burner assembly or burner orifice.
• Installation other than as instructed in this manual.
Any such action may cause a fire hazard
WARNING
Fire Risk
Provide adequate clearance:
• Around air openings
• For service access
Locate appliance away from traffic areas
24in MIN
(610mm)
Figure 2
Clearance measurements are distances from the edge of the flame,
not from the centre.
© Copyright 2004 - 2021 EcoSmart Inc. All rights reserved. 0721
5
72in MIN
(1,829mm)
24in MIN
(610mm)