Publicité
Instructions for installation
p. 13/16
6.4. Roof installation
Install the roof support slats. Start with the strip of LEDs on the rear wall.
Insert the roof elements and screw them to the cabin walls. Observe the cable
outlets.
Install the cover slat, inside.
6.5. Installing interior fittings
Install the infrared radiator. Fit the radiator flush with the rear side of the radiator
cover. Position the radiator cover in the cut-out and screw it to the rear wall.
Please note that the terminal box for the radiator must be at the top.
Mount the ventilation slide.
Install the bench support slats.
EN
Place the upper and lower benches on the bench support slats provided for this
purpose.
Screw the bench foot to the upper angled bench and screw the other end of this
to the rear upper bench. Finally, screw the bench foot to the wall element.
6.6. Installing the electrical equipment
You need a hole measuring Ø 2 cm in the cable shaft for the heater supply cable.
Drill the cable outlet at a right angle and route the cable as far as the roof to the
2
power unit for the sauna control (5 x 2.5 mm
).
Repeat for the heater sensor - Ø 1 cm - 15 cm below the ceiling.
Repeat for the bench sensor - Ø 1 cm, opposite the heater sensor on the rear
wall - 15 cm below the ceiling.
To cover the cables, use the cable cover slat. Shorten them with a saw as required.
Route the data cable for the control panel up to the cabin roof, to the power unit
for the sauna control.
Publicité
