Instructions for installation
6. Assembling the cabin
ATTENTION!
The cabin is designed for both "right-hand" and "left-hand" assembly.
Please observe the floor plans on pages 10 and 11, depending on model.
Observe the figures starting on page 17.
6.1. Installing wall elements
Start assembly with the "Wall element, bottom rear - Ventilation element" and
the "Element, bottom right". The lower parts can be identified by the projecting
connecting strips. Screw the elements at a right angle (see tip on page 4) from
outside. Repeat this with the left side wall. The rear wall is thus installed between
the side walls.
When assembling the upper sections, again start with the rear wall (Element,
top rear). Make sure this is flush with the connecting strip of the lower rear wall.
Screw both sides of the upper rear wall to the projecting strip of the lower rear wall.
Screw the upper wall elements together.
Note that each upper wall element must be screwed to the protruding
strip of the lower wall element.
6.2. Assembling the glass elements
Screw the "Elements with groove for glass" to the side walls from outside. Fit the
"Element above door" and additionally screw in from above.
Fit the aluminium U-profiles flush with the glass elements.
Please note that when you install the "glass element with
holes for door hinges", you are defining the direction in which the door
opens (see option 1 and 2).
Position the glass element centrally in the door frame, paying attention to straight
alignment and the position of the struts. Slide the glass element to the left or
right, respectively, into the groove in the corner posts.
Insert the "Mounting rail above door" between the glass elements.
6.3. Completing the cabin exterior
Install the "Covers, front" by screwing from the inside - flush with the inner side.
Pay attention to the element with cut-out for the control panel - this can be fitted
on the left or right.
Install the "Cover, top front" above the glass by screwing from the inside.
Mount the "Cover slats, outside" using screws.
p. 12/16